Uploaded November 2024 | Updated November 2026, 3 hours ago
Alley Cat was originally made for the Atari 8-bit computers by Bill Williams and John Harris in 1983 and released by Synapse Software. While a fine game on that platform, Alley Cat had a lot of competition and it is perhaps most well-known by its PC port. IBM published several high quality ports of games originally developed on other platforms during the lifespan of the IBM PC and PCjr. Alley Cat was one of the last of these releases. The company shortened its name to SynSoft when IBM was performing publishing duties.
Alley Cat as designed to run on an IBM PC with a CGA card and optionally supports a joystick. On the surface, the CGA support is not particularly impressive. Only the two BIOS-supported color palettes are used, there is no support for artifact color, more colorful modes or alternate palettes. It has support for the PCjr.'s special music chip for its opening song and can display alternate palette colors during the game but is still limited to four colors on screen at any one time.
One thing you will almost never see in YouTube videos showing off this game is Alley Cat's manipulation of the border color. CGA cards were designed to show a border on the left and right sides of the monitors of the day. This was important so text characters would not be cut off by a monitor's bezel. For similar reasons, the top and bottom of the screen would also have a border as not all monitors provided an external control to adjust the line height.
In the most commonly used CGA graphics mode, 320x200 with four colors, predefined into one of two palettes, the color select register on the card can set the background color to any of the 16 colors CGA can display. When the background color changes, the border color changes as well. There is BIOS support for this feature, which is why it works when Alley Cat is run on an EGA or VGA card. The area outside the active screen area was not always black. DOSBox does not, in its mainline builds, support showing the border color. DOSBox-x may and 86Box does support showing border color changes but for this capture I decided to use original hardware.
For the first part of this video I have brought out my Tandy 1000 SX, running it in slow mode for 4.77MHz 8088 performance. As I am running an original disk image through a Gotek with Flash Floppy firmware, the PCjr. enhancements are unavailable on this system. Then for the second part of this video, I brought out my PCjr and put the Gotek into it. I recorded the RGBI output of each system via an RGB2HDMI connected to a Datapath VisionRGB E1s while watching the game displayed by the SX and PCjr.'s composite video output. The audio output was recorded through the RCA audio output from the SX and PCjr., which is much easier than using alligator clips on a PC or XT. Control was provided with a Tandy Deluxe Joystick and a IBM PCjr. Attachable Joystick. Both captures were upscaled to a proper CGA 5:6 pixel aspect ratio and combined into one video.
The PCjr. gives the prompt "Are you using a TV or an external speaker" whereas the PC does not. This is necessary because the PCjr.'s enhanced sound chip can only be heard by an external speaker. If you respond with N, you will hear the same PC Speaker music played on a PC. The PCjr. is slower than the PC because Alley Cat does not use RAM above the first 128K area but for the most part the game speed is the same as the PC.
Several screens in Alley Cat change border color. The most notable example is inside the Aquarium Room's fish bowl. On this screen, as Freddy swims around, he changes color as he starts to run out of air. He is using the background color, so the borders change colors as he does. If he touches an electric eel, the screen will flash bright white. The background and border flash green during the bonus score screen and red in the Kennel when the dogs give a warning growl. The background and border color changes from black to blue when you grab a gift box and flashes blue when you reach Felicia in the Cupid Room at the end of each round.
Alley Cat was originally made for the Atari 8-bit computers by Bill Williams and John Harris in 1983 and released by Synapse Software. While a fine game on that platform, Alley Cat had a lot of competition and it is perhaps most well-known by its PC port. IBM published several high quality ports of games originally developed on other platforms during the lifespan of the IBM PC and PCjr. Alley Cat was one of the last of these releases. The company shortened its name to SynSoft when IBM was performing publishing duties.
Alley Cat as designed to run on an IBM PC with a CGA card and optionally supports a joystick. On the surface, the CGA support is not particularly impressive. Only the two BIOS-supported color palettes are used, there is no support for artifact color, more colorful modes or alternate palettes. It has support for the PCjr.'s special music chip for its opening song and can display alternate palette colors during the game but is still limited to four colors on screen at any one time.
One thing you will almost never see in YouTube videos showing off this game is Alley Cat's manipulation of the border color. CGA cards were designed to show a border on the left and right sides of the monitors of the day. This was important so text characters would not be cut off by a monitor's bezel. For similar reasons, the top and bottom of the screen would also have a border as not all monitors provided an external control to adjust the line height.
In the most commonly used CGA graphics mode, 320x200 with four colors, predefined into one of two palettes, the color select register on the card can set the background color to any of the 16 colors CGA can display. When the background color changes, the border color changes as well. There is BIOS support for this feature, which is why it works when Alley Cat is run on an EGA or VGA card. The area outside the active screen area was not always black. DOSBox does not, in its mainline builds, support showing the border color. DOSBox-x may and 86Box does support showing border color changes but for this capture I decided to use original hardware.
For the first part of this video I have brought out my Tandy 1000 SX, running it in slow mode for 4.77MHz 8088 performance. As I am running an original disk image through a Gotek with Flash Floppy firmware, the PCjr. enhancements are unavailable on this system. Then for the second part of this video, I brought out my PCjr and put the Gotek into it. I recorded the RGBI output of each system via an RGB2HDMI connected to a Datapath VisionRGB E1s while watching the game displayed by the SX and PCjr.'s composite video output. The audio output was recorded through the RCA audio output from the SX and PCjr., which is much easier than using alligator clips on a PC or XT. Control was provided with a Tandy Deluxe Joystick and a IBM PCjr. Attachable Joystick. Both captures were upscaled to a proper CGA 5:6 pixel aspect ratio and combined into one video.
The PCjr. gives the prompt "Are you using a TV or an external speaker" whereas the PC does not. This is necessary because the PCjr.'s enhanced sound chip can only be heard by an external speaker. If you respond with N, you will hear the same PC Speaker music played on a PC. The PCjr. is slower than the PC because Alley Cat does not use RAM above the first 128K area but for the most part the game speed is the same as the PC.
Several screens in Alley Cat change border color. The most notable example is inside the Aquarium Room's fish bowl. On this screen, as Freddy swims around, he changes color as he starts to run out of air. He is using the background color, so the borders change colors as he does. If he touches an electric eel, the screen will flash bright white. The background and border flash green during the bonus score screen and red in the Kennel when the dogs give a warning growl. The background and border color changes from black to blue when you grab a gift box and flashes blue when you reach Felicia in the Cupid Room at the end of each round.


![Tandy Radio Shack TRS-80 Model 1 Gaming on Original Hardware
Earlier this month I obtained a Tandy/Radio Shack TRS-80 [Model 1] Computer, one of the 1977 Trinity of home computers. The TRS-80 was originally more popular than the Apple II or Commodore PET and sold far many more units than Tandy Corporation expected it to sell. It was discontinued at the end of 1980 with the introduction of new limits by the FCC on the emission of RF noise.
The TRS-80 was not particularly known as a gaming machine, but there were hundreds of games written for it. Games came on cassette tape and later floppy disk. Most cassette-based games require a machine with Level II BASIC and 16KiB of RAM, which is what my system has. Many games focused more toward the TRS-80 Model III or IV can still be run on a Model I with 48KiB and disk drives.
The graphics capabilities of this system are extremely modest. There is no color and per-pixel addressable semigraphics have an effective resolution 128x48 pixels. Apple or PC Speaker-like audio can be heard via the cassette output jack. Input usually keyboard only, which is how I am playing these games and why I sucked so hard. The Z80 CPU runs at 1.77MHz, which is slow even by 8-bit standards.
For this video I picked four famous or impressive games. Dancing Demon was a very popular piece of entertainment software for the TRS-80. Frogger and Zaxxon are very impressive and officially licensed ports. Frogger and Zaxxon both implement countdown timers telling the user exactly how long the program has to load. I edited out most of the counts and loading. Sea Dragon is another game which may have been more impressive on other systems, but it is pretty amazing it works as well as it does here.
The TRS-80 Computer had a special display you can purchase, but it also could be connected to a home TV via an RF adapter. However, the 64-column text mode used an effective 384x192 resolution, which would make the text a bit difficult to read on a home TV. (You can see the 32-column text when the Dancing Demon program announces Let the show begin). The Power, Video and Cassette connectors on the TRS-80 all use 5-pin DIN connectors, and I used a DIN to composite video cable to get the signal from the computer.
As the computer uses a composite video connection, I figured it would be quite possible to capture a high quality image via my Datapath VisionRGB E1s as I did with the Apple II once I eliminated its color burst signal. And with a component to VGA cable and then a VGA to DVI adapter, I was able to get the image. The signal required a fair bit of tweaking before I could get text across the screen without shimmer and to reduce video noise. I do not believe anyone else has uploaded a capture of similar quality to Youtube from original hardware.
When the system is loading from cassette or drawing graphics with text, there may be some phase shimmer. This appears to be normal. Also, sometimes graphics will show random flickery lines, this is also normal as the CPU and the video display hardware fight for RAM access. Tandy Radio Shack TRS-80 Model 1 Gaming on Original Hardware](https://i.ytimg.com/vi/c3n4OA7D_MA/mqdefault.jpg)





![Ultima I + II PC-9801 Complete Soundtrack
Ultima I and II were converted to the NEC PC-9801 computer in the late 1980s for sale in Japan. Both games ports were published by Pony Canyon. Ultima I was ported from the IBM PC-DOS version to PC-9801 by DeskTop, Inc. Ultima II was rewritten from scratch by DeskTop, Inc. and JH1NRR.
All Origin Systems and Sierra Online versions of Ultimas I and II were without music, leaving Ultima III as the first Ultima series entry with original music. The port of Ultima I for the Apple IIgs had music but that port was released in 1994, long after Ultima I had any currency. That is what makes the Pony Canyon ports special: Japanese composer Takeshi Yasuda (安田毅) https://vgmpf.com/Wiki/index.php/Takeshi_Yasuda wrote a number of original pieces for the ports of these two titles. As some tracks are shared between the two games, we present the music of both games in a single video. While some songs, such as Castle and Town, are rather generic, Ultima IIs Title, Tower, Hot and Cold Planet pieces are stand-outs and, in our opinion, worthy of being included in the Ultima music canon.
Getting the PC-9801 versions to play music requires a PC-9801-26 or compatible sound card on real hardware, or an emulator that is configured to emulate that sound card along with its Sound BIOS. The latter aspect is not trivial, as the ROM file must be supplied by the user, and neither Neko Project nor DOSBox-X display any error message when they cannot find the ROM file; you just will not hear any music.
The NEC PC8801mkIISR versions have the same music with somewhat different arrangements, even as the YM2203 sound chip is the same. The Fujitsu FM-Towns version of the Ultima I-III Trilogy CD plays music that was seemingly composed for Ultima III in inappropriate locations in Ultimas I and II as well, but more on that in a future video.
The music was captured to the .VGM format using Neko Project and rendered to .WAV using NukedOPN2 running at the chips native clock rate, then downsampled to 44.1 kHz using SOX. As the FM instruments sound overly bright, a first-order low-pass filter with a corner frequency of 3.68 kHz was applied, bringing the frequency spectrum closer to that of normal music.
Track list:
00:00 - Ultima I Title [I]
00:56 - Wandering [I+II]
01:29 - Castle [I+II]
03:27 - Town [I+II]
05:15 - Dungeon [I+II]
06:09 - Space Travel [I]
06:40 - Fight Against Mondain [I]
07:33 - Ultima II Title [II]
08:27 - Tower [II]
09:39 - Hot Planet [II]
10:40 - Cold Planet [II]
11:32 - Minax Castle [II]
12:55 - Ending (Rule Britannia) [I+II]
The final song is forty seconds long, we do not know why it goes on for longer. Ultima I + II PC-9801 Complete Soundtrack](https://i.ytimg.com/vi/fXCccDMD8VA/mqdefault.jpg)

