Uploaded April 2010 | Updated November 2026, 3 hours ago
Watch those center caps! They can be tough to get off! Try to use a blade & push into the 4 cornes of the slit. That should weaken the bond & hopefully allow you pop off the cap off. When you're done, just use a dab of super glue to keep the caps on. Just enough that you can pop it off again if needed.
This is really only necessary if your cube is too tight, too loose, or your core is broken. So if the default tensions are good, don't worry about this. You'll also have to get the tensions just right on the V-Cube 6 before you glue/reglue in your pins.
The Cube4You cores are here:
cube4you.com/cube4you-orange-core-p-36.html
For me, 5 of them cost me $6.28 & came in a week & a half. (They even gave me an extra one!)
Size Screws:
V-Cube 5 & 6:
4-40x 1"
(2.5 cm)
V-Cube 7:
4-40x 1-3/8"
(3.5 cm)
Watch those center caps! They can be tough to get off! Try to use a blade & push into the 4 cornes of the slit. That should weaken the bond & hopefully allow you pop off the cap off. When you're done, just use a dab of super glue to keep the caps on. Just enough that you can pop it off again if needed.
This is really only necessary if your cube is too tight, too loose, or your core is broken. So if the default tensions are good, don't worry about this. You'll also have to get the tensions just right on the V-Cube 6 before you glue/reglue in your pins.
The Cube4You cores are here:
cube4you.com/cube4you-orange-core-p-36.html
For me, 5 of them cost me $6.28 & came in a week & a half. (They even gave me an extra one!)
Size Screws:
V-Cube 5 & 6:
4-40x 1"
(2.5 cm)
V-Cube 7:
4-40x 1-3/8"
(3.5 cm)










