Uploaded December 2021 | Updated November 2026, 18 hours ago
LTspice can be used to quickly and easily simulate a charging capacitor in an RC circuit using a transient analysis. The issue with the transient analysis, is that it assumes that capacitors are already fully charged and are therefore treated as open circuits. To make sure this isn't a problem, you need to set the initial conditions on the capacitor to be at 0 volts.
This video goes through all the steps you need to simulate a charging capacitor and includes a bonus tip on how to change the thickness of the lines in the simulation plot - by default, they are, in my opinion, far too skinny.
For more about charging and discharging capacitors, including more SPICE simulation, check out:
electronx.ca/education/dc-circuits/dc-chapter-16
which includes introductory circuits courses based around the free and open source text book - Lessons in Electric Circuits by Tony Kuphaldt.
LTspice can be used to quickly and easily simulate a charging capacitor in an RC circuit using a transient analysis. The issue with the transient analysis, is that it assumes that capacitors are already fully charged and are therefore treated as open circuits. To make sure this isn't a problem, you need to set the initial conditions on the capacitor to be at 0 volts.
This video goes through all the steps you need to simulate a charging capacitor and includes a bonus tip on how to change the thickness of the lines in the simulation plot - by default, they are, in my opinion, far too skinny.
For more about charging and discharging capacitors, including more SPICE simulation, check out:
electronx.ca/education/dc-circuits/dc-chapter-16
which includes introductory circuits courses based around the free and open source text book - Lessons in Electric Circuits by Tony Kuphaldt.










