Uploaded November 2020 | Updated September 2026, 2 weeks ago

---

This is Part 3 of 3 for the 5 stone diamond pendant. In part one, we covered the designing of the pendant. Part two was setting up for 3d printing, then printing the pendant, as well as what is required for casting.

Part 1 - Designing the Pendant: youtu.be/K9xQJ4pD2XA
Part 1 Blog: myjewelrybench.com/5-stone-diamond-pendant-part-1-designing
Part 2 - 3d Printing and Settings for your investment burnout: youtu.be/kH-AJ-JqGcY
Part 3 - Cleaning up the casting and stone setting:

Need 3d Printing, Jewelry or Watch Repair Tools? Check out my Amazon Page:
amazon.com/shop/petergrande


If you like these videos, please subscribe and give a Thumbs UP!
Every Little Bit Helps!

For more jewelry and watch related repair info, visit my website at
myjewelrybench.com

If you would like to help keep this channel funded, consider
a donation at
patreon.com/myjewelrybench
#jewelrymaking, #jewelrydesign, #3dprinting