Uploaded July 2018 | Updated November 2026, 5 days ago
All of the axes (X, Y and Z) have been connected from the Pokeys57CNC interface to each of the stepper motor drivers. The stepper motor drivers have also been connected to all of the stepper motors on the machine. I test these stepper motors using Mach3 and then I explain how to determine the steps per inch and the acceleration and velocity in motor tuning.
Office Website:
buildyourcnc.com
Where you can find this interface:
buildyourcnc.com/item/electronicsAndMotors-electronic-component-breakout-Mach4-mach3-USB-ethernet-Board
All of the axes (X, Y and Z) have been connected from the Pokeys57CNC interface to each of the stepper motor drivers. The stepper motor drivers have also been connected to all of the stepper motors on the machine. I test these stepper motors using Mach3 and then I explain how to determine the steps per inch and the acceleration and velocity in motor tuning.
Office Website:
buildyourcnc.com
Where you can find this interface:
buildyourcnc.com/item/electronicsAndMotors-electronic-component-breakout-Mach4-mach3-USB-ethernet-Board










