Uploaded September 2023 | Updated September 2026, 1 week ago

---

#21 Weekly 3D PRINTS
Hey everyone, I've faced some printer issues lately. My Ender3 was under-extruding due to worn brass gears, so I replaced them but then hit an under-bite problem. The E motor's been missing steps, leading to fragile models with missing filaments. Also, my Artillery Sidewinder X2's probe stopped reaching out, causing an error. Before that, it produced a lot of material. If you've encountered similar challenges, drop a comment. Happy printing!

More about Mintion:
👉 mintion.net

Buy Mintion | Beagle V2 Camera | 3D Printer Camera
👉 mintion.net/products/mintion-beagle-v2-3d-printer-camera

Buy Mintion | Beagle V2 Camera | 3D Printer Camera from Amazon
👉bitly.ws/Kgat

Buy Beagle UV Sensor
👉 reurl.cc/qLpMMp

Buy 3D Printer Tools Kit
👉 amzn.to/41aKKDg

Suspended Hand by STomHacks
👉printables.com/model/573397-suspended-hand

I hope you found this video and learned something new! If you did, then please leave a like💖 and make sure that you’re subscribed🔔. and good bye!