Uploaded September 2018 | Updated September 2026, 2 hours ago
This is a short video (2:11 minutes) of the beta 3DChameleon 2 color mechanical color changer installed on a Flashforge Inventor II changing between two colors. The video starts off with the printer completing the raft of a sample gecko print. It then removes the raft color (red) from the extruder and loads in the secondary color (gray). The version of the 3DChameleon installed here is a beta of the two color unit. 4 and 8 color units are available as well. The 2 color beta is available now for $49 for those interested in helping us test it out. Currently, we support the Flashforge Inventor II, Flashforge Finder and the Creality CR (10, 20 & X) series and the Creality Ender 3.
For more information on participating in the beta, contact me via email directly at bill {at} 3dchameleon {dot} com.
This is a short video (2:11 minutes) of the beta 3DChameleon 2 color mechanical color changer installed on a Flashforge Inventor II changing between two colors. The video starts off with the printer completing the raft of a sample gecko print. It then removes the raft color (red) from the extruder and loads in the secondary color (gray). The version of the 3DChameleon installed here is a beta of the two color unit. 4 and 8 color units are available as well. The 2 color beta is available now for $49 for those interested in helping us test it out. Currently, we support the Flashforge Inventor II, Flashforge Finder and the Creality CR (10, 20 & X) series and the Creality Ender 3.
For more information on participating in the beta, contact me via email directly at bill {at} 3dchameleon {dot} com.
