Uploaded June 2026 | Updated September 2026, 2 days ago

---

Grab the free guide, Why Your 3D Prints Won’t Stick: 30 Common Causes:
itsmeadmade.myflodesk.com/bodpngai7k

If your 3D prints keep coming loose from the bed, curling at the corners, or turning into spaghetti, this video will help you narrow down what might be going wrong. I’ll walk through 7 simple things I check first when a print will not stick, so you can stop guessing and start troubleshooting your first layer with more confidence.

Get on the 3D Print Guild waitlist:
itsmeadmade.myflodesk.com/guild-waitlist

Great Build Plates for Better Adhesion:
BIQU Cryogrip Plates: amzn.to/3UJHtKi
Bambu Lab SuperTack: tidd.ly/3HQyHan

More Helpful Links
📰 Sign up for my monthly newsletter & weekly print tips
itsmeadmade.myflodesk.com/newsletter

🛠️ 3D Printer Maintenance Toolbox List
bit.ly/MeaDsTooLs

MeaD's Must Haves for 3D Printing:
itsmeadmade.com/3d-printing-must-haves

Good Cheap Filament:
Kingroon PLA: amzn.to/3Vff7rn
Kingroon PLA Triple Silk: amzn.to/4mVElXF

Favorite Rainbow Filaments:
❤️ Flashforge Rapid PLA: amzn.to/45xWpkT
Creality Rainbow: amzn.to/4640oFY
Kingroon Matte Rainbow: amzn.to/4mWxNIk
Ziro Fast Color Change: amzn.to/4oQ1QmL
iSanmate Rainbow: amzn.to/45wN6lb


00:00 Introduction
00:43 Free Guide
01:13 Clean Plate
02:09 First Layer
03:06 Bed Leveling
04:04 3D Print Guild
05:04 First Layer Speed
05:30 Temperature Settings
06:54 Use Brims
07:21 Part Cooling
08:16 Quick Recap
09:39 Free Guide

DISCLAIMER: This video is not sponsored. Some of the links are affiliate links in which I will receive a small commission.