Uploaded February 2022 | Updated November 2026, 2 days ago
When working with 3D printing there are times when you just can’t get your part to fit within your printer. You can flip your part around, run it on a funny angle, or even try scaling it……but at the end of the day, sometimes you just have to cut the part in half to make it work.
When working with 3D printing there are times when you just can’t get your part to fit within your printer. You can flip your part around, run it on a funny angle, or even try scaling it……but at the end of the day, sometimes you just have to cut the part in half to make it work.










