Vez3D | 3D Printing at 1000 MM/s ?? Magnum+/ODrive/ #1000mms @Vez3D | Uploaded May 2021 | Updated October 2024, 20 hours ago.
Personal challenge and stupid idea of trying to print at 1000mm/s.
Great learning experience! If you want to try this challenge, please tag and share with me your result. I would be very to hear your experience!
-Printer: VzBoT (Custom designed/built) 330x330x400mm grabcad.com/library/vzbot-1
-Klipper
-Odrive V3 system
-270 KV motors
-Pressure Advance 0.003
-Input_shaper tuned with Accelerometer
-MGN12 rails Y MGN9 rail X
-Magnum+
-PT100
-Hextrudort from HevORT direct drive. miragec79.github.io/HextrudORT
-Custom EVA X carriage modded for Magnum+ https://main.eva-3d.page/
-0.3mm retract
-280C ABS
-PEI coted flex plate
-10mm Z smooth rods
-1 single Z motor, 2:1 gear ratio
-0.4mm nozzle
-0.1mm layer height
(PS: dont judge the bad 40T pulleys in the back. They were 5mm ID bore, drilled to 8mm without a press drill, as a temporary solution until I receive new one. They are dancing crazy)
Personal challenge and stupid idea of trying to print at 1000mm/s.
Great learning experience! If you want to try this challenge, please tag and share with me your result. I would be very to hear your experience!
-Printer: VzBoT (Custom designed/built) 330x330x400mm grabcad.com/library/vzbot-1
-Klipper
-Odrive V3 system
-270 KV motors
-Pressure Advance 0.003
-Input_shaper tuned with Accelerometer
-MGN12 rails Y MGN9 rail X
-Magnum+
-PT100
-Hextrudort from HevORT direct drive. miragec79.github.io/HextrudORT
-Custom EVA X carriage modded for Magnum+ https://main.eva-3d.page/
-0.3mm retract
-280C ABS
-PEI coted flex plate
-10mm Z smooth rods
-1 single Z motor, 2:1 gear ratio
-0.4mm nozzle
-0.1mm layer height
(PS: dont judge the bad 40T pulleys in the back. They were 5mm ID bore, drilled to 8mm without a press drill, as a temporary solution until I receive new one. They are dancing crazy)