Uploaded June 2019 | Updated November 2026, 1 day ago
In this video we are going to make an overhead camera standard with dumble weights and a 3D printed holder. The standard is easy to move around the entire table, so you can easily work from multiple angles and also make the best shots while recording your clip.
I am making this dumble booth amusing because I was looking for a solution to easily change my camera angle while filming, without having to walk to a tripod every time. Moreover, I wanted the camera to easily stand on a table and be used as an overhead camera.
▼ The things I used in this video are:
- Manfrotto 244RC Variable Friction Arm
- Manfrotto Lighting Stud 3/8
- Sony RX100 V5 Camera
- 2x Dumble Weights
▼ The software I used is:
- Fusion 360
- Simplify3D
▼ Visit my website for 1001 ideas and tips:
- 3d-printcreator.com
▼ Support my work through a donation via PayPal
- support.3d-printcreator.com
Thank you for watching the video.
Brian, 3D PrintCreator.
In this video we are going to make an overhead camera standard with dumble weights and a 3D printed holder. The standard is easy to move around the entire table, so you can easily work from multiple angles and also make the best shots while recording your clip.
I am making this dumble booth amusing because I was looking for a solution to easily change my camera angle while filming, without having to walk to a tripod every time. Moreover, I wanted the camera to easily stand on a table and be used as an overhead camera.
▼ The things I used in this video are:
- Manfrotto 244RC Variable Friction Arm
- Manfrotto Lighting Stud 3/8
- Sony RX100 V5 Camera
- 2x Dumble Weights
▼ The software I used is:
- Fusion 360
- Simplify3D
▼ Visit my website for 1001 ideas and tips:
- 3d-printcreator.com
▼ Support my work through a donation via PayPal
- support.3d-printcreator.com
Thank you for watching the video.
Brian, 3D PrintCreator.










