3. Pokeys57CNC Connect a Stepper Motor and Test with Mach3 @PatrickHoodDaniel
3. Pokeys57CNC Connect a Stepper Motor and Test with Mach3  @PatrickHoodDaniel
Uploaded July 2018 | Updated November 2026, 2 days ago
In this video, I demonstrate how to construct the stepper motor driver ribbon cable to be used on a typical stepper motor driver. I connect the cable and test the stepper motor using the Pokeys57CNC interface and Mach3

Pokeys57CNC Playlist:
youtube.com/playlist?list=PL6PplMTH29SETy_UYRcKQDspJOin_lzDB

Buildyourcnc.com Website:
buildyourcnc.com

Pokeys57CNC Product Page on Buildyourcnc:
buildyourcnc.com/item/electronicsAndMotors-electronic-component-breakout-Mach4-mach3-USB-ethernet-Board
3. Pokeys57CNC Connect a Stepper Motor and Test with Mach3Fabricator Pro 8x17 CNC Router Build in Wisconsin Part 1Your CNC Electronics are NOT WORKING. How to diagnose!blackTooth Assembly Instructions Part 728. How to Interface an LCD to an ARM Microcontroller Tutorial - Part 15Mach3 USB Controller - Setup, wiring and Configuration Part 1CNC EMI Investigation: Router Noise Testing & Teardown and Getting to Know My Oscilloscope#7 ARM Microcontroller Tutorial - Changing the Clock to 48Mhz Using the GNU Library50. How to connect a Hobby Servo to the ARM Microcontroller Part 2 - ARM STM32 MicrocontrollerCNC Routing Process (CAD, CAM and CNC Control) Variant 2: Part 2 Finishing the Design in AutoCADblackTooth Assembly Instructions Part 836. How to: ADC Convert and Show Raw Temperature Sensor Reading - STM32 ARM Microcontroller Part 3
BuildYourCNC |

3. Pokeys57CNC Connect a Stepper Motor and Test with Mach3

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER