Uploaded October 2017 | Updated September 2026, 12 minutes ago
112 parts for Autodesk AU printing on 21 Printrbots. I need 500 parts by end of next week, so I’m doing some bot-farming. Over 100 are already printing, with 112 more printing today. At 100/day, it looks like I’ll be fine, but probably going to put 30+ into service. They improve incrementally w new slices and tweaks so I’ll end up with lots of extras. If can be frustrating getting started, but I’m having fun now that all bots are up and printing multiple parts.
I now belong to a small club again ;) it’s been a while. At 21 bots, it’s nowhere near any sort of record- there are much bigger farms.
If you run a bot-farm, share your setup and put me to shame!
Happy printing,
Brook
112 parts for Autodesk AU printing on 21 Printrbots. I need 500 parts by end of next week, so I’m doing some bot-farming. Over 100 are already printing, with 112 more printing today. At 100/day, it looks like I’ll be fine, but probably going to put 30+ into service. They improve incrementally w new slices and tweaks so I’ll end up with lots of extras. If can be frustrating getting started, but I’m having fun now that all bots are up and printing multiple parts.
I now belong to a small club again ;) it’s been a while. At 21 bots, it’s nowhere near any sort of record- there are much bigger farms.
If you run a bot-farm, share your setup and put me to shame!
Happy printing,
Brook
