Uploaded September 2021 | Updated November 2026, 10 hours ago
3D printed Polycarbonate alternator housing and stator components
16 N52 4"x0.5"x0.5" magnets, arranged for 8 poles (NN-SS-NN-SS-NN-SS-NN-SS).
12 coils, 68 turns each, 17 gauge wire (~717 feet)
3 - phases, 4 coils per phase in a 2 series/2 parallel configuration
4 or 5 silicon steel shims per coil to transfer the magnetic flux through the coils and to reduce eddy current losses. Magnetic performance was simulated using FEMM.
The math says it should do 36 amps at 250 RPM @ 4.7 volts charging a 1S x many parallel li-ion battery pack. Cut in speed at 4.7 volt is 74.8 RPM, lower if the batteries are less than full.
3D printed Polycarbonate alternator housing and stator components
16 N52 4"x0.5"x0.5" magnets, arranged for 8 poles (NN-SS-NN-SS-NN-SS-NN-SS).
12 coils, 68 turns each, 17 gauge wire (~717 feet)
3 - phases, 4 coils per phase in a 2 series/2 parallel configuration
4 or 5 silicon steel shims per coil to transfer the magnetic flux through the coils and to reduce eddy current losses. Magnetic performance was simulated using FEMM.
The math says it should do 36 amps at 250 RPM @ 4.7 volts charging a 1S x many parallel li-ion battery pack. Cut in speed at 4.7 volt is 74.8 RPM, lower if the batteries are less than full.










