Prusa 4.4.1 stuttering Moen 2023-02-18 | Everything is explained heregithub.com/prusa3d/Prusa-Firmware-Buddy/issues/2821
Prusa mini+ Stuttering on fast moves Moen 2022-12-11 | github.com/prusa3d/Prusa-Firmware-Buddy/issues/2821Firmware version 4.4.0
MM3 Marble Gate V1 Moen 2022-04-07 | Same from an other angleFrom model posted by wintergatan 6. april 2022This model i downscaled to 79% to match the 15,9 mm marbles I had laying around.At the end there I am going a bit to fast. then slowing down to a more confertable high speed. Escapement wheel/anchor seems to work fine there is no back rotation when pulling. But when pushing the wheel goes a little counterclockwise.The arm that is holding the lower marble requires more force than i expected. I am not sure if that is a huge issue. It is a detail to consider.I am a bit worried about the flex in the front part. Some crossmembers will be helpfull in holding it together. The flex is also caused by that there is no rigid mounting to the tube.
MM3 Prototype Marble Dropper V1 Moen 2022-04-07 | From model posted by wintergatan 6. april 2022This model i downscaled to 79% to match the 15,9 mm marbles I had laying around.At the end there I am going a bit to fast. then slowing down to a more confertable high speed. Escapement wheel/anchor seems to work fine there is no back rotation when pulling. But when pushing the wheel goes a little counterclockwise.The arm that is holding the lower marble requires more force than i expected. I am not sure if that is a huge issue. It is a detail to consider.
Divide by 8 for marbles Moen 2021-06-26 | A divider that takes one lane in and outputs 8.At 1:30 i am explaining how the hooks works when they are adjusted in reverse sequencual order.Video uploaded in connection to wintergatan community on discord.
