Uploaded May 2017 | Updated September 2026, 3 days ago
Follow me on Instagram: instagram.com/jdeechambers
I've dreamed of having a CNC plasma cutting table for a very long time, and after saving up for one I decided it was finally time to make it happen. But before I set up the table, I decided to take the time to get the space the table is going set up right from the beginning, because I know that if I wait to do it later it might never happen. I clean out the backside of my barn, before framing in the old sliding door so I can eventually take it out. I also run air lines and electrical, before installing a new air compressor. Lastly, I grab the farm's big air compressor that we use to blow down combines in the summer to blow out the rafters and walls, getting the area as clean as possible to start off with.
Follow me on Instagram: instagram.com/jdeechambers
I've dreamed of having a CNC plasma cutting table for a very long time, and after saving up for one I decided it was finally time to make it happen. But before I set up the table, I decided to take the time to get the space the table is going set up right from the beginning, because I know that if I wait to do it later it might never happen. I clean out the backside of my barn, before framing in the old sliding door so I can eventually take it out. I also run air lines and electrical, before installing a new air compressor. Lastly, I grab the farm's big air compressor that we use to blow down combines in the summer to blow out the rafters and walls, getting the area as clean as possible to start off with.
