Uploaded February 2023 | Updated September 2026, 1 day ago

---

Now that the round table is ready we can finish the levers …
↓↓↓ Complete description, time index and links below ↓↓↓

In the last video (link below) we set up the round table for milling radii on different work pieces (link below). The first parts to get a radius milled are the levers (links below). And there are two more operations left to be carried out on them.

We start off milling a slot into the C-clamp side of the levers. Then we mill a radius on the other side so it blends in nicely with the round handle (link below). Finally we cut a M6 thread at that side so we can screw both together.

00:00 Intro – three operations left
01:10 Milled (1) – 2mm C-clamp slots
03:31 Milled (2) – 9mm 180° radius
09:10 Cut – M6 thread
10:14 Wrap-up – back to the big parts, bye

Dual Electronic Engine Control Lever IP68 youtube.com/playlist?list=PLwq-2MnM58FLQ468e5-wzV6_MeqT4Zd5T
Dual Electronic Engine Control Lever IP68 (1): Project Kick-Off youtu.be/hPBkBoe81jY
…
Dual Electronic Engine Control Lever IP68 (6): Levers (1) youtu.be/UZPrt9G_c_0
Dual Electronic Engine Control Lever IP68 (7): Levers (2) youtu.be/l_Xy6iEkE9A
…
Dual Electronic Engine Control Lever IP68 (16): Round Table Setups youtu.be/RkzBEMVtfWk
Mailbag: Tools, POM, O-Rings, Screws, Washers and Springs youtu.be/in2AuTcGgqw

#throttle #lever #ip68 #robertssmorgasbord