The Lightning Stalker
Laser Diode Extraction and Pressing Into a Module
updated
If the blender is started from a resting state, oscillation usually does not occur, although it will sometimes begin to oscillate spontaneously. Also if there is much water in the pitcher it will not occur at all. If the blender is pulsed so that the water begins sloshing up and down and then quickly switched to a continuous mode, the oscillation is most likely to begin. It is quite stable and I saw it continue for about 5 minutes without any sign of cessation. Longer tests were not conducted.
In 1998 I found a video camera in the trash. It had a remote pause button and other accessories. The only thing wrong with it was a dead battery.
Dries in 5-10 minutes
I Don't See the Branches, I See the Leaves by Chris Zabriskie is licensed under a Creative Commons Attribution license (creativecommons.org/licenses/by/4.0)
Source: http://chriszabriskie.com/dtv
Artist: http://chriszabriskie.com
We affectionately refer to this cat as Half Stash because of the white patch of fur under his nose. He's a little wild baby and always runs away from people.
Recorded Oct 2016
Twitter: @lgtngstk
Buy one on Gearbest: gearbest.com/brushless-fpv-racer/pp_765192.html
Some TF fluxes are not water or alcohol soluble. This method effectively removes nearly any type of flux.
Twitter: @lgtngstk
Twitter: @lgtngstk
Twitter: @lgtngstk
Twitter: @lgtngstk
He gets really loud sometimes with his caterwauling.
Twitter: @lgtngstk
Have you ever wondered how an ozone generator works? Well, it's an electronic device, fairly simple in design, that uses a high voltage transformer to produce an electrical corona. This splits oxygen molecules into atomic oxygen, but atomic oxygen is extremely unstable. Some of it recombines into O₂, but some will also bind with other O₂ molucules, making O₃, or ozone, but this is a weak, unstable bond.
One of the oxygen atoms is easily given up. When ozone encounters another molecule that contains carbon or some other compound that reacts with oxygen, one of the oxygen atoms flies off and destroys the other molecule in an extremely violent chemical reaction. It basically burns it, even at room temperature. Ozone is so unstable that it will even do this to other ozone molecules, recombining into O₂. It doesn't stick around for very long.
The microcontroller present in the TEC.BEAN ozone generators is actually not even necessary. It's only there to provide timing and receive button presses to reduce power consumption under battery power.
amazon.com/dp/B07252HF4S/ref=cm_sw_r_tw_dp_x_o1NPzbEDSR81V
http://www.thelivingairpurifier.com
http://www.sonix.com.tw/article-en-1006-3129
Twitter: @lgtngstk
Twitter: @lgtngstk
Fast forward to today and trying to load it into the current version, and the Video 1 timeline grayed out for some reason and all the edits "froze".
So here it is partially complete and with long sections of unedited video locked into it.
Some of my better video editing is evident for a few brief moments.
@3:28 you might want to skip ahead to 9:10 to avoid a long unedited section.
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
In this type of model, the flight controller continuously adjusts each ESC to maintain stable flight. Motors and propellers are attached to a frame to provide air movement and lift, almost as if it's climbing on the air.
Hobbyists sometimes will attach cameras to these to provide stunning aerial video and another live video feed that is transmitted to FPV goggles or a screen for a real-time "virtual reality" type experience, but it's actual reality! The typical radio frequencies used are 5.8GHz for the live video and 2.4GHz for the control link, although lower frequencies are sometimes used to increase range.
A big thank you to my subscribers for hitting the 1000 mark. Each and every one of you is a blessing. DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
rotorbuilds.com/build/1491
Twitter: @lgtngstk
rotorbuilds.com/build/1494
FrSky Taranis X9D Plus w/SMA Mod
Fat Shark HD3
Realacc RX5808 Pro Diveristy receiver
Aomway RHCP SMA
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
Retest with all solder connections, actually more like 14V
Result: 860g thrust
ESC: FVT Littlebee 30A-S
Battery: Thunder Power RC Adrenaline series TP1800-4SA55X
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
Diatone Tyrant 150 PNF w/upgrades
FVT Little Bee 20A
DYS X30303
DYS BX1306-4000KV
Grayson mini action cam
Turnigy Graphene 3S 1.3
Turnigy iA8C SBUS DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
http://www.2dogrc.com/diatone-tyrant-150-pnf-orange-quad.html
Betaflight 2.9.1
PIDs:
Roll P: 88 I: 40 D: 5
Pitch P: 105 I: 40 D: 5
Yaw P: 70 I: 45
OneShot125 enabled
Everything else is default for 2.9.1
Props: DYS X30303 triblades
Motors: DYS BX1306-4000
ESC: 20A LittleBee OPTO PRO flashed with BLHeli 14.6 Damped Light
1x EEU-FR1E102 and SMB8J18CA added to protect the FPV hardware from voltage spikes
Recorded with Skyzone SKY02 DVR goggles
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
Here is a good setup video: youtu.be/EymBdEgu4cA
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
My gaming channel:
youtube.com/channel/UCJj8NScrRzdop511qM7thXA
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
I am preparing more video of the Propanator. If you subscribe, you won't miss a thing.
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
For transmitters, expect this to work up to about 150MHz. Above that the 1/4" (6mm) area of mismatched dielectric and 1/2" (12mm) of shield could become significant. It can cause reflection and increase SWR. RF weirdness most need not worry about
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
Twitter: @lgtngstk
More details here: http://laserpointerforums.com/f49/liquid-sky-laserjet-4p-polygon-mirror-92392.html
The original laser diode, driver, and lenses have been removed. (Undocumented HP ASIC and nearly useless invisible IR)
Ardiuno Uno 2kHz - 1MHz square wave pulse generator for clock snigal
5 - 24V depending on RPM speed (More RPM = More volts)
Green laser = GearBest XY-016, Will probably swap for a FastTech module
Six sided polygon mirror (Hexagon)
HP P/N#s
RG5-0449 Laser/Scanner Assembly
RH7-1146 Polygon Mirror
It is basically nothing more than an HA13480S breakout board with an onboard motor.
Pinout: docs.google.com/spreadsheets/d/1giPHY5AjbTY6ZaOmZh_7XAZg6cHTlOTW5V5Ek6vyi4w/edit?usp=sharing
HA13480S Datasheet: http://www.mikrocontroller.net/attachment/191456/ha13480.pdf
Arduino Code: http://pastebin.com/i3Z9RHQQ
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
http://www.survivallaserusa.com/Eagle_Pair__190-540nm_Standard_Laser_Safety_Goggles/p1667092_7862033.aspx
This is not a toy. Do not use it to play with your cat or dog. Do not allow children or teenagers to use one. Do not point it at the face of any human or animal. Insects are okay. A blind fly is much easier to swat. BE RESPONSIBLE.
Link to the full review:
http://laserpointerforums.com/f52/gearbest-laser-301-high-power-405nm-blue-light-zoomable-laser-pen-92098.html
USE COUPON CODE LASERCM AND GET ONE,
ONLY $6.59!
http://www.gearbest.com/led-flashlights/pp_105699.html
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
Cree BA19-08027OMF-12DE26-2U_00 Manufactured 2013
Cree is sending a replacement, but it doesn't ship until December 1. Says they are out of stock at the factory ๏̯͡๏
Links to shatadeets:
L6562A Transition-mode PFC controller
http://web.arrownac.com/sites/default/files/pdfs/L6562A.pdf
Cree XLamp XB-G High-Voltage White
http://www.cree.com/LED-Components-and-Modules/Products/XLamp/Discrete-Directional/XLamp-XBG
Forum post:
http://www.photomacrography.net/forum/viewtopic.php?t=22033
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
We will eat of his flesh, drink his blood, and his power will become ours.
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
Music - course.it
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
I thought at first that I would have to buy stubby drill bits in order to be able to load the tooling. That turned out not to be the case!
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
UPDATE: They are issuing me a partial refund for the 200mW module minus the cost of a 50mW module, so I'm happy, I guess, but I really did want a 200mW module, even if it's mostly IR!
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk


