SARB Semi auto rubber-band blaster Prototype assembly video Boomchacle 2025-01-06 | Download files here. thingiverse.com/thing:6688991Apologies for my voice being so quiet for the first half of the video. It was like 4 AM and I didn't want to wake anyone up.At 15:56, I didn't specify, but you need to use light silicone oil. I recommend pure silicone oil with no additives and a cSt of 100 or less. Any other form of oil could damage the rubber, plastic, or get rancid.
KSP VTOL, Phoenix Boomchacle 2024-10-13 | Craft file: kerbalx.com/Boomchacle/VTOL-PhoenixThis is the next VTOL in the faerie VTOL line. The Phoenix is an approxmately 70 ton supersonic VTOL with two sets of three whiplash engines that can swivel 90 degrees to hover. Due to the use of heavy landing gear for the front and rear, I included a medium landing gear in the front, which allows you to steer the plane on the runway.Press 1 to hover and press 2 to fly straight. Press 3 to toggle the large landing gear and steer the aircraft.
KSP VTOL aerobatics Boomchacle 2024-07-28 | Bendy tech supersonic VTOL. It is based on the Faerie VTOL's artstyle, although it uses a completely different chassis and slightly different hinge system.It's not a SSTO, the rapiers are just used to achieve high speed.KerbalX craft file link belowkerbalx.com/Boomchacle/VTOL-Roc
Semi auto rubber band foam blaster WIP Boomchacle 2024-06-28 | Thingiverse link: thingiverse.com/thing:6688991Put the darts in, put the magazine in, spam the trigger. Takes about 30 seconds to load a magazine. It's very low power since it's just a single rubber band powering each one. It also doesn't require electricity and just uses your finger to actuate the barrels.
KSP stock+ Orion drive Boomchacle 2024-05-27 | Craft file link. kerbalx.com/Boomchacle/Orion-DriveUses DLC to overclock fireworks for thrust. I like the explosion effect.Press 1 to start and 2 to stop. Press 2 right after the explosion to minimize probability of rapid disassembly.3 opens pod bay doors and 4 fires a single shell.
One second touch Boomchacle 2024-03-30 | The speedrun time would be much longer than my other video, but touching the island was substantially faster with this one and the kerbal survived, so I am calling it here for this challenge XD. Good luck with this one XDPeeper leviathan did a comeback and tied the 1 second markyoutu.be/pNBtTE3Ssrs?si=2gs6MnUq4c3ZwCiB
2 second touch, 5 second overall time Boomchacle 2024-03-30 | AND I DID IT WITH A SUBMARINEI concede the mass driver strategy for this speedrun mode. KAL overclocked engines are too powerful.
Four second touch. Boomchacle 2024-03-02 | Touched the island in 4 seconds. If you use , and . to go frame by frame at 0:15, you can see the explosion happens right at the end of 4 seconds.Beaten by FamiliarNameMissing on 3/16/2024 youtube.com/watch?v=wU1lik83-JYI guess I'm up. might take a while.
The Iron Faerie Boomchacle 2024-02-25 | Tutorial on the "VTOL, Iron Faerie" on KerbalX. Carries 7 guided missiles. Uses ghost tech. Full stock with no DLC. At 13:35 just imagine the free bird solo in your head cause there's no way I'm nuking my channel for that lol.kerbalx.com/Boomchacle/VTOL-Iron-Faerie
Kerbal Space Program. Island in 11 seconds. (9 second touch) Boomchacle 2024-02-19 | I see you whippersnappers getting good times, and I respect that. They're truly epic runs.(EDIT Actually you know what, I'm going to cut out the center section with all the lag just to make the video easier to bear. The run was verified a year ago on the speedrun website with the full video and it's in game time anyways. If this causes issues, I'll just undo the edit since youtube saves the video anyways.)But I am not going to sit back and let a week's work get forgotten XDI originally made this video about a year ago. Going by your guys's rules, this is a 9 second run. Good luck.If you see this before the other runs got cut out by youtube's editor, the run starts at 13:00
KSP VTOL launched Guided AGM test 1 Boomchacle 2024-02-19 | This is another demonstration attempting to push the limits of stock technology. The VTOL uses no modded or DLC parts. Once I polish it up a bit, I'll upload it to KerbalXAs you can see, I didn't hit the targets lol.
VLS missile test 2 Boomchacle 2024-02-17 | I made this video to be used as the kerbalX video. As you can see, it's not as reliable as the launch clamp version.This is the final version I will work on for now. It's such a finicky and inconsistent system that I can't be bothered.KerbalX link.kerbalx.com/Boomchacle/VLS-missile-carrierV3For a detailed explanation of why this system is unreliable, the missiles use target hold as their aiming system. The glitch that allows this contraption to work keeps the missile and main craft as part of the same craft. This means that whenever the main craft makes slight movements, the missile itself moves in the opposite way to try and compensate even though it doesn't need to. If you can help fix this problem, I'd be appreciative,
KSP Stock fire and forget missile system test Boomchacle 2023-11-23 | Heavily inspired by HB Stratos and his fire and forget missile.
KSP nerv gimbal cluster Boomchacle 2023-11-14 | Pitch, yaw, and roll control. As you may be able to tell, it will rapidly disassemble itself under too many gees.
Ghost tech KSP Boomchacle 2023-08-19 | This device is used to make separated craft which are all controlled by one craft.Craft file link. kerbalx.com/Boomchacle/Ghost-tech-Glitch-demonstrationThe weird behavior with the kerbal's chair and the rover is likely due to the interaction between the forced autostrut heaviest that wheels have. When the kerbal was in the chair, it was the heaviest part, and when it was out of the chair, it was not the heaviest part so the wheels weren't strutted to it. That's my theory anyways.
Planting a flag on the Kerbal space center flag pole. Boomchacle 2023-08-12 | Craft file. kerbalx.com/Boomchacle/EZ-VTOL-Pole-landing
KSP stock Heavy ATGM carrier (Craft file link in description) Boomchacle 2023-08-09 | kerbalx.com/Boomchacle/ATGM-carrier-Heavy-turreted-mk2V2
KSP Stock tow missiles Boomchacle 2023-06-21 | Download and directions for use. The missiles are guided by hand using WASD. It does not use DLC or mods.kerbalx.com/Boomchacle/Wire-guided-missile-carrier
Stock HEAT-FS Experience Boomchacle 2023-03-09 | Yes, the round I modeled isn't actually a HEAT shell but I don't care.
KSP space in 1 frame (glitches) Boomchacle 2023-02-08 | (Edit The title used to be "speedrunning the space% speedrun category in under 2 minutes"Edited out the loading screen.
KSP discord Super challenge 8 hard mode. Boomchacle 2022-10-09 | Have you ever wanted to see a probe core punch through an entire planet?2:18 : Probe gets fired at 226,909 m/s
Budget spinlaunch KSP Boomchacle 2022-09-25 | "Mom, can we get spinlaunch?""We have spinlaunch at home!"Spinlaunch at home:
KSP Breech loading cannon Boomchacle 2022-09-02 | This turret is stock and does not use DLC to operate.To use:1. Stage once to start the engines.2. Stage again to decouple the first round3. Press 1 to open the breech and center the round for the autoloader4. Press 2 to ram the round into the breech, wait a few seconds for the solar panel to completely extend before proceeding.5. Press 3 to retract the rammer and close the breech.6. Press Z and X really quickly to fire the gun.To reload, start from step 2 again.Aiming is done through WASD. I recommend locking a target and using the SAS target hold feature to assist your aim because it helps a lot with stability. I will upload this craft to KerbalX.kerbalx.com/Boomchacle/Falling-block-breech-turret
KSP one part to duna Boomchacle 2022-05-16 | This took quite a while lol. I had to quicksave a large number of times to get the duna intercepts right. I don't count kerbals as parts because... they're not. Kerbal EVA packs are slightly OP lol. The kerbal is stranded at duna but I'm sure he'll have plenty of rocks to look at.
KSP Island Express 22 seconds. Glitchless. Boomchacle 2022-05-09 | This video has been edited to cut out most of the lag. The full video is linked here. youtube.com/watch?v=Gl9OThiHMU0
KSP Stock speed record: Getting a kerbal to 15 percent the speed of light without cheats or glitches Boomchacle 2022-05-08 | I clipped around 2500 vector engines into each other and had them fire a kerbal in a chair into space.Kerbal loads in space at 1:50. And by speed record, I'm talking about the manned speed record.Full video here. Just a lot more loading so there's no real reason to watch it. youtube.com/watch?v=Qrv2AmV1R4A
KSP Speedrun Space% 26 seconds Boomchacle 2022-05-06 | *moar boosters intensifies* Sorry for the loading times as well. The game doesn't exactly like this.speedrun.com/ksp/full_game#Space
Single frame to space in KSP Boomchacle 2022-05-05 | From the moment the kerbal is effected by thrust, it only takes a single frame for him to get to space lol. Glitchless WR? pls?
3D printed 4X 2/3 AAA battery bank Boomchacle 2022-03-27 | I made this specifically to hold four 2/3 AAA batteries in series for a 5 Volt laser. The batteries slide in and contact a strip of foil, and the end cap carries wires attached to springs which act as leads. I still need to make a switch for it though. If anyone wants the files, ask and I’ll upload it, although it is far from perfect.
Homemade belt feed testing Boomchacle 2022-03-19 | This is for a nerf gun I’m making. Some minor issues prevent it from cycling which mostly stem from the stroke length and the belt not being in the right position.
Homemade nerf gun action cycling. Boomchacle 2022-03-06 | A belt fed pump action Revolver isn't exactly a normal action but it's pretty interesting. Once I make this fully automatic it will make more sense.
You can get to orbit just using nuclear engines Boomchacle 2022-02-27 | Saw Reid Captain's video and decided to try it myself.
Flying Decimator over Oshur Boomchacle 2022-01-15 | The video is potato quality to give you the old oshur style! The game didn't load the assets in unless you had high graphics settings during the test, so I needed to scale down the resolution to minimum.
Sprocket 10,000 + kilometers per hour. Boomchacle 2021-11-10 | It went from 0 to past the edge of the map in 0.8 seconds. Comparing that to a video of a guy doing 4000 kilometers per hour, it took his machine a bit over 2 seconds to get to the edge of the map from starting his acceleration. This one uses a gun to propel itself with negative shell length so it's not really comparable though.
Sprocket: The most mobile tank destroyer ever Boomchacle 2021-09-24 | The thing is about 25 tons and can climb almost every obstacle.
150 mm autoloader Boomchacle 2021-09-06 | For a ship gun I'm designing. The weapon uses 2 stage ammunition to achieve a velocity exceeding 1000 meters per second and the ammo handling system allows it to sustain a rate of fire of about 28 rounds per minute.
Angled armor penetrator animation Boomchacle 2021-08-30 | This projectile is specifically designed to penetrate extremely angled armor while carrying a HE payload. This is an animation, not a simulation. If you want to simulate something like this, please do :D It works by having a ring shaped charge cut a notch in the armor, which allows the rest of the penetrator to follow through. I'm not sure which would be more optimal, a very high hardness steel projectile with a slightly softer cap or a slightly softer steel projectile and a tungsten cap. The reason i think this shell could actually use an extremely hard cap is due to the lack of an ogive on the front to cause a ton of yaw moment on the projectile. (other than the wind screen)
HEAT Assisted APHE warhead Boomchacle 2021-08-25 | 150 mm shell. Uses a circular linear shaped charge to Pre perforate a ring in the armor, then the blunt penetrator to shear the rest out through the plugging effect. This is not a simulation but is simply hand animated. Since it's not a real shell and it doesn't really use a HEAT warhead, it'd be more correct to call this a "Linear shaped charge assisted APHE" round. Also, the time gets slower during the HEAT activation because otherwise you wouldn't be able to see it form.
3OF82 125 mm HEF Explosion animation Boomchacle 2021-05-31 | This is not a simulation, but an animation. I hand animated the entire thing :D Took a little while lol. It is based on a real projectile called the 3OF82 high explosive fragmentation round. It's missing the fin assembly and aerodynamic nose cone because those would take even longer to render and animate.I’ll mark it #shorts cause it’s short
3OF82 shell details (Russian HEF) Boomchacle 2021-05-27 | I will eventually make an animation of this exploding, but I am still unsure the direction of the fragments. Made because Anthony Mcbride requested it.
Short Infiltrator montage Boomchacle 2021-04-24 | Why the heck is an infiltrator able to take a headshot from a bolt action though? that's really silly.
Planetside 2 logic Boomchacle 2021-04-22 | The anti material rifle can't kill infiltrators in one hit, but the revolver can.If you're confused as to the first segment, There was a glitch which made my revolver look like the anti material rifle. I was using the revolver for the first few shots when the scope was offset.
