Chris Borge | 3D Printed Fractal Vise Build Guide @Borgedesigns | Uploaded August 2021 | Updated October 2024, 7 minutes ago.
This is the build guide for my vise. its a longer video but I figure if your making one being to specific cant hurt. I hope this covers everything.
Files: thingiverse.com/thing:4931700
Source files: dropbox.com/sh/7bpgve4as4jl0lq/AAApnlVQ8KqblNU9pDvvBI38a?dl=0
Music: Islabonita - An Jone
Follow my socials:
Instagram: borge_design
twitter- twitter.com/borgey5
thingiverse- thingiverse.com/borgey/designs
Timestamps:
0:00 intro
0:26 non printed hardware
01:14 part printing orientation
01:37 small jaws
06:06 TPU jaw
06:27 leadscrew filing
7:00 begin assembly
18:33 outro
Like subscribe all that stuff
My name is Chris, I am a 3D printing hobbyist from australia. I dont really specialise in anything specific, but 3D printed tools and tabletop accessories are some things youll probably seen quiet often. I do all my 3d printing on a Ender 3, which I highly recommend as a budget printer. Currently I only run 1 printer but I hope to expand that in the future. Recently acquired a photon 0 to do resin printing with. I like to share all my 3D printing ideas for free although I do plan to sell stuff in the future. Most of my projects will be mostly 3D printed with a few non printed components included, these can often be found on ebay. I actually use the cheapest filament I can get for all my projects, again I hope to change this in the future.
This is the build guide for my vise. its a longer video but I figure if your making one being to specific cant hurt. I hope this covers everything.
Files: thingiverse.com/thing:4931700
Source files: dropbox.com/sh/7bpgve4as4jl0lq/AAApnlVQ8KqblNU9pDvvBI38a?dl=0
Music: Islabonita - An Jone
Follow my socials:
Instagram: borge_design
twitter- twitter.com/borgey5
thingiverse- thingiverse.com/borgey/designs
Timestamps:
0:00 intro
0:26 non printed hardware
01:14 part printing orientation
01:37 small jaws
06:06 TPU jaw
06:27 leadscrew filing
7:00 begin assembly
18:33 outro
Like subscribe all that stuff
My name is Chris, I am a 3D printing hobbyist from australia. I dont really specialise in anything specific, but 3D printed tools and tabletop accessories are some things youll probably seen quiet often. I do all my 3d printing on a Ender 3, which I highly recommend as a budget printer. Currently I only run 1 printer but I hope to expand that in the future. Recently acquired a photon 0 to do resin printing with. I like to share all my 3D printing ideas for free although I do plan to sell stuff in the future. Most of my projects will be mostly 3D printed with a few non printed components included, these can often be found on ebay. I actually use the cheapest filament I can get for all my projects, again I hope to change this in the future.
