2008 Mexican Government Learjet 45 XC-VMC ATC & Crash Animation @chilloutJr

Uploaded July 2026 | Updated September 2026, 3 hours ago

Video Source: youtube.com/watch?v=gHflklaXY8s

2008 Mexican Government Learjet 45 XC-VMC ATC & Crash Animation

Lapa tragedy in 3D: reconstruction of the last minutes of the plane (Spanish narrator)

ATC - ASE 529 - [Propeller blade failure] 21 August 1995

United Airlines Flight 811 ATC Recording with Transcript

$ATC - 2008 Tanker 09 Lockheed SP-2H N4235T crash - [LOC after Engine Failure] 1 September 2008 Audio Source: Accident Aviation (https://www.youtube.com/watch?v=5rzQOVL4wSw) falsely identified as 2002 Tanker 123 crash Lockheed SP-2H Neptune, Tanker 09, was destroyed after impacting terrain following a loss of power and loss of control about 2 miles northwest of the Reno/Stead Airport, Nevada. The accident flight crew had flown 1 firefighting support mission on the morning of the accident. The purpose of the accident flight was to support the Smitty fire, which was located about 85 nautical miles south of Reno. Just after the airplanes landing gear was retracted during takeoff, a ball of fire was observed coming out of the left jet engine before the airplane rolled steeply to the left and descended into the terrain. Prior to takeoff, the captain said he would make the takeoff and provided a takeoff briefing concerning the runway to be used and his intentions should an emergency develop. Shortly thereafter, the captain informed the co-pilot that this would actually be his (the co-pilots) takeoff. On the cockpit voice recorder, the co-pilot stated Same briefing (sound of laughter). The co-pilot did not give an additional takeoff briefing beyond the one given by the captain and the captain did not ask the co-pilot to give one. During the initial climb, the captain said he detected a fire on the left side of the airplane and the copilot responded that he was holding full right aileron. At no point did either pilot call for the jettisoning of the retardant load as required by company standard operating procedures, or verbally annunciate the jet engine fire emergency checklist. Recorded data showed that the airplanes airspeed then decayed below the minimum air control speed, which resulted in an increased roll rate to the left and impact with terrain. The 11th stage compressor disc of the left jet engine failed in fatigue, which caused a catastrophic failure of the compressor section and the initiation of the engine fire. Metallurgical examination of the fracture identified several origin points at scratches in the surface finish of the disk. The scratches were too small to have been observed with the approved inspection procedures used by the company. A review of the FAA sanctioned Approved Aircraft Inspection Program, revealed no shortcomings or anomalies in the performance or documentation of the program. A post-accident examination of the airframe and three remaining engines revealed no anomalies that would have precluded normal operations. Probable Cause: PROBABLE CAUSE: The failure of the flight crew to maintain airspeed above in-flight minimum control speed (Vmca) after losing power in the left jet engine during initial climb after takeoff. Contributing to the accident was the crews inadequate cockpit resource management procedures, the failure of the captain to assume command of the airplane during the emergency, the flight crews failure to carry out the jet engine fire emergency procedure, and the failure of the crew to jettison the retardant load.$