Uploaded October 2023 | Updated September 2026, 2 weeks ago
Several weeks ago, I wanted to cut this board on my original CNC Mill. Then everything went to hell in a hand basket. I had to rebuild a computer, acquire some CNC Software and then make everything work again Lots of problems but today we cut the 1st board.
This board is an Rx RF Amp stage that I want to fit in the V.2 Shirt Pocket SSB Transceiver. The whole radios is 16 cubic inches so not much room. Thus, an SMD untuned RF amplifier stage.
The board matches the layout.
Pete N6QW
Several weeks ago, I wanted to cut this board on my original CNC Mill. Then everything went to hell in a hand basket. I had to rebuild a computer, acquire some CNC Software and then make everything work again Lots of problems but today we cut the 1st board.
This board is an Rx RF Amp stage that I want to fit in the V.2 Shirt Pocket SSB Transceiver. The whole radios is 16 cubic inches so not much room. Thus, an SMD untuned RF amplifier stage.
The board matches the layout.
Pete N6QW
